Search
Ever-Power WPA 250 AC motor reducer worm gear reducer motor reducer WP series reducer, the worm is made after 45# high-quality steel heat treatment, the worm wheel is cast with tin bronze, which has good wear resistance, especially in the load The ability is more obvious, mainly suitable for the reduction drive of plastics, metallurgy, beverages, mining, lifting and transportation, chemical construction and other mechanical equipment.
A. Features:
1. Stable transmission, low vibration, low impact, low noise, large reduction ratio, strong versatility, suitable for various mechanical equipment.
2. Single-stage transmission, large transmission ratio and compact structure.Most reducers have good self-locking performance, which can save the braking device of mechanical equipment with braking requirements.
3. The meshing friction loss between the worm gear and the worm gear tooth surface is relatively large, so the transmission efficiency is lower than that of the gear, and it is easy to heat and the temperature is higher.
4. Higher requirements for lubrication and cooling.
5. Very good match.Worms and worms are manufactured according to national standards.
B. Working conditions:
1. The speed of the worm reducer should not exceed 1500r/min.
2. The working environment temperature is -40℃ to +40℃. When the working environment temperature is lower than 0℃, the lubricating oil must be heated to above 0℃ before heating, and when the working environment temperature is higher than 40℃, take cooling Measures must be taken.
3. The feed shaft of the worm gear reducer can rotate forward or backward.
C. Note:
1. Worm gear shafts must not be used as input shafts.
2. The machine does not pump oil when it leaves the factory.Before operation, sufficient mechanical oil must be added.
3. The supporting motor (ie power) shall not exceed the value specified in the mark.
4. If the user wants to change the direction of entering the shaft, please remove the lower end cover of the shaft, take out the worm and adjust 180.Load it.Do not knock on the door forcefully during installation. You can slowly drive the two shafts to engage them.
