The EP Greenhouse geared motor is a concise and lightweight reduction geared motor with a built-in limit switch system that’s suitable for assembly of a locally available electric motor. The geared motor can be used in manually-controlled or climate-controlled ventilation and display systems in greenhouses. The quick and easy-to-install EP geared motor is definitely rainproof and windproof. The gear reducer includes a high protection course (IP65) and can be utilized in an ambient temperature of 0-60 °C.

The low-noise gear reducer for Greenhouse includes a gearwheel transmission and a worm wheel transmission, which are integrated within an aluminum precision housing. The self-braking worm wheel transmitting means that the drive shaft is definitely locked when the decrease geared motor is not running. The completely sealed reduction reducer comes with an expansion chamber with a diaphragm to keep the gear oil at a low pressure under all conditions, even at high temperatures. Thanks to the use of an expansion chamber, the reducer could be installed in any placement. There are no restrictions, because there is no need for a bleed plug. The sealed reduction reducer keeps the apparatus essential oil of the gear reducer in optimal condition for its entire operating life time. The geared motor is suitable for discontinuous use, working course s3-30%, with a maximum activation time of 25 minutes.

The Gear box reduction gearbox has an FT85 motor assembly flange, to which a suitable IEC standard motor can certainly be installed (EN 50347).

The Gear box includes a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit change system is installed in an integrated chamber and is enclosed by an impact-resistant plastic-type cover. The limit switch system is accessible and easy to adjust. The limit change system’s optimum switching range is certainly 40 or 64 revolutions of the drive shaft. The cabling is connected in spring-clip connections. The gear driver comes with an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.

The gear reducer for greenhouse includes 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates are available as accessories.

Maximum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of program of 4-pole electric motor.
Protection class IP65.
May be used in ambient temperatures of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, optimum activation time 25 a few minutes.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installing IEC regular motor (EN 50347).
Maximum switching range of limit switch program 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).