Observing several guidelines for right installation is important to your dependable and appropriate operation with the gearbox or gear motor.
The guidelines set out listed here are intended being a preliminary manual to selecting gearbox or gear motor. For helpful and suitable installation, observe the directions offered from the set up, make use of the maintenances guide for your gearbox accessible from our income department.
Following is really a quick outline of installation principles:
a) Fastening:
Place gearbox on the surface giving satisfactory rigidity. Mating surfaces must be machined and flat.
Mating surfaces has to be inside of definite geometric tolerances (see guide). This is primarily true of flange-mounted gearboxes with splined hollow shafts.
In applications that involve high radial loads at the output end, flange mounting is advisable for some gearbox sizes as this mounting helps make use of the double pilot diameters provided in these gearboxes.
Make certain the gearbox is ideal for your demanded mounting position.
Use screws of resistance class eight.eight and more than to safe the gearbox. Torque up screws towards the figures
indicated during the appropriate tables.
With transmitted output torque better than or equal 70% with the indicated M2max torque, and with
regular motion reversals, use screws with minimum resistance ten.9.
Some gearbox sizes may be fastened working with either screws or pins. Of pin seated from the frame the gearboxes be no less than one.five times pin diameter.
b) Connections
Safe the connection components to gearbox input and output. Do not tap them with hammers or very similar equipment.
To insert these parts, utilize the support screws and threaded holes provided around the shafts. You should definitely clean off any grease or protects through the shafts ahead of fitting any connection components.
Fitting hydraulic motors.
Be cautious the O ring among motor flange and gearbox input flange when assembling. Set up the
hydraulic motor in advance of filling lube oil in to the gearbox.
Connecting the hydraulic brake.
The hydraulic circuit really should be this kind of to be sure that brake is released instants in advance of gearbox commences and utilized after gearbox has stopped. Check that stress during the hydraulic line for brake release is at zero anytime gearbox is stopped.
Path of rotation
Motors are connected on the ideal electrical or hydraulic circuit based on their path of rotation.
When executing these connections, keep in mind that all gearboxes, no matter if within the in-line or appropriate angle style and design, have the very same route of rotation each at input and output. For extra details of the connection of electric and hydraulic motors, see relevant sections on this catalogue.